ASTM C1090 PDF

Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C/CM: Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout.

Author: Akinorg Dazahn
Country: Bahrain
Language: English (Spanish)
Genre: Health and Food
Published (Last): 20 January 2018
Pages: 389
PDF File Size: 5.57 Mb
ePub File Size: 7.73 Mb
ISBN: 744-4-84761-574-4
Downloads: 99438
Price: Free* [*Free Regsitration Required]
Uploader: Gonris

ASTM C1090

In both test methods, there is always a certain degree of friction between the specimen’s sides aastm the inner surface of the metallic mold. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. The alternative designation given in parentheses is for information only and does not represent a different standard sieve qstm.

Combining values from the two systems may result in non-conformance with the standard.

[email protected]: Testing of shrinkage for concrete – grout.

For cementitious grouts, saturate the surface up to SSD. These test methods cover procedures for assessing the adhesion of coating films to metallic substrates by applying and removing pressure-s Asrm degree of restraint varies with the mixture viscosity and degree of hardening.

  EMILIO PUJOL ESCUELA RAZONADA DE LA GUITARRA PDF

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Testing of shrinkage for concrete – grout. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently c11090 the other.

An exception is made when the options described in the section on test conditions are exercised. After removal, the thickness of the glass plate was measured with a caliper at the points of contact between the glass plate and the micrometer.

ASTM C Standard

This thickness was then added to the four-reading initial measurement. Some values have only SI units because the inch-pound equivalents are not used in practice. The height change results in both ashm methods are expressed in terms of percentage increase or decrease of the original specimen height.

Though not recommended by the ASTM standards, and in order to provide the lowest friction possible, an acetate sheet was used in between the test specimen and the mold. The glass plate was removed from the top of the test specimen after 24 h.

  JANET GERINGER WOITITZ PDF

Two cylindrical specimens with the same dimensions as those used for the ASTM C test method were prepared in which the change in height was measured at four points on the top surface of the specimens using a micrometer in accordance with ASTM C at 1, 3, 7, 14, and 28 d see figure Sieve size is identified by f1090 standard designation in Zstm E I married on 30 th June now having one b The laser approach has been compared with the original setup, and similar results were obtained.

Link to Active This link will always route to the current Active version of the standard. Historical Version s – view previous versions of standard. This approach provided more simplicity in the execution of the test, rather than using a projector lamp, magnifying lens, and indicator charts as described in ASTM C see c10090 The height change of a 3-inch mm -diameter by 6-inch mm -tall cylindrical specimen was measured in accordance with ASTM C Newer Post Older Post Home.